Amphenol
Protec ve
4-Pin female
cap
connector
Connect the CAP M2 Power
Do not connect or disconnect the power cable at the Mains connector while power is on. Turn off Mains
power before connecting the power cable at the unit, then, engage mains power again.
Connect the Power connector as appropriate for this installation:
"Connect the Mains Power to the CAP M2" on page 39
"Connect a Hybrid Fiber Splice Box" on page 40
•
•
Connect the Mains Power to the CAP M2
Locate the Mains power cable that was delivered with the CAP M2.
Locate or install a suitable power junction box or receptacle near the unit and route the power cable from
1
the power source to the CAP M2.
2
Do not connect the cable to the unit's Mains connector at this time. The power source must be
interruptible.
The Mains cable must be properly secured observing local regulations and electrical codes. Be sure to
allow enough slack in the cable at the CAP M2 to plug or unplug the cable into the Mains connector.
Dependent on the type of power supply used by the unit, wire the power cable to the junction box or
receptacle. Refer to the color code and pin numbers shown in:
3
Figure 6 on page 38
Figure 8 on page 39
•
•
M0203AHA_uc
© August 2022 CommScope, Inc.
4
3
CAP M
2
Mains
connector
Figure 8. CAP M2 DC Power Cable
/
Figure 7 on page 38
for the US or EMEA AC power cables
for the DC power cable.
2x
end splice
Black
Red
1
CommScope ERA
Powering on a Fiber CAP M 2
®
CAP M2 with Fiber Interface
Page 39