Connect The Fiber Cap M2 To A Passive Rf Antenna - CommScope ERA CAP M2 Manual

Attach the ring end of the wire to the chassis ground stud on the bottom, right side of the CAP M2, as
shown in the graphic below.
5
Chassis ground stud
Use the Keps nut removed in
Route the free end of the chassis grounding wire to an approved (per local code or practice) earth ground
6
source.
7

Connect the Fiber CAP M2 to a Passive RF Antenna

The following sections guide you through connecting the CAP M2; complete these procedures in the order in
which they are presented.
"Clean the RF Cable Connectors" on page 30
"Connect the Passive RF Antenna" on page 32
•
•
M0203AHA_uc
© August 2022 CommScope, Inc.
Step 4 to secure the ground wire to the chassis-ground stud.
Connect the Cables to the Fiber CAP M2
CommScope ERA ® CAP M2 with Fiber Interface
Page 29