Table of Contents
Advertisement
TO BE COMPLETED BY THE INSTALLER
All models
Cabinet Level: Ensure the appliance is level and dimensions accurate.
Refer to 'Cabinetry Dimensions', pages 14 – 15.
Anti-tip: Ensure the appliance is securely fastened to the cabinetry with the supplied
anti-tip bracket and fittings. Refer to 'Cavity preparation', page 30.
Door panel/and toe kick: Ensure door panel/s and toe kick are attached securely and
properly aligned; Refer to 'Door panel installation', pages 41 – 43, and 'Toe kick
installation', pages 43-45.
Doors closing freely: Ensure the door/drawer can open and close freely with no
resistance from surrounding cabinetry or product. Refer to 'Door clearance' and
'Drawer clearance', page 21.
Hinge pin: Ensure hinge limiting pin is fitted for 90° door swing. Refer to
'Door clearance', page 21.
Vent clearance: Ensure the cabinet installation provides the minimum vent clearance
required. Check that the gap between the bottom of the door panel and the ground
is at least 50mm. Refer to 'Product Dimensions', page 13.
Installation trims: Check all Installation Trims are present and fitted securely.
Complete and keep for safe reference:
Model
Serial No.
Purchase Date
Purchaser
Dealer Address
Installer's Name
Installer's Signature
Installation Company
Installation Date
FINAL CHECKLIST
Door opening sensor: Ensure magnets and sensors are correctly installed by checking
that the door alarm is not beeping and that compartment lights are on when door
is opened.
Packaging: Ensure all internal and external packaging has been removed. Refer to
'Before installation', page 28.
Fault codes: Ensure no error codes are shown.
Installation mode: Ensure the Installation Mode is de-activated (hold on Compartment
button for 4 sec. Refer to 'Power and water supply connection', page 37.
User guide: Check the User Guide is inside the product in a visible area for the customer.
For products with water only or Ice and water function
Ice maker: Turn ice maker ON. Force a manual ice maker cycle by pressing the (alarm
symbol), - & + buttons together for 4 seconds then close the door(s). The ice tray will
fill and empty into the bin below, dry the bin and return it correctly. Refer to page 19 of
your User Guide.
Dispenser: Ensure the water is flowing through the system using the dispenser pad.
Refer to page 18 of your User Guide.
63
Advertisement
Table of Contents
