Final Checklist - Fisher & Paykel RS6121S Installation Manual

TO BE COMPLETED BY THE INSTALLER
ALL MODELS
F Cabinet Level: Ensure the appliance is level and dimensions accurate.
Refer to 'Cabinetry Dimensions, pages 16-17'.
Anti-tip: Ensure the appliance is securely fastened to the cabinetry with the supplied
F
anti-tip bracket and fittings. Refer to 'Cavity preparation, page 29'
F Door panel/and toe kick: Ensure door panel/s and toe kick are attached securely
and properly aligned; Refer to 'Install door panel, pages 40-42 and 'Install toe kick',
pages 42-43.
F Doors closing freely: Ensure the door/drawer can open and close freely with no
resistance from surrounding cabinetry or product. Refer to 'Door clearance' and 'Drawer
clearance', page 19.
Hinge pin: Ensure hinge limiting pin is fitted for 90° door swing. Refer to 'Door
F
clearance', page 19.
Vent clearance: Ensure the cabinet installation provides the minimum vent clearance
F
required. Check that the gap between the bottom of the door panel and the ground is at
least 50mm. Refer to 'Product dimensions', page 12.
F Side trims: Ensure the side trims are securely attached. Refer to 'Install trims',
pages 46-47.
Door opening sensor: Ensure the magnets at door are in place so door opening sensor
F
works properly. Refer to 'Install trims', page 47.
Complete and keep for safe reference:
Model _____________________________________________________________
Serial No. _____________________________________________________________
Purchase Date _____________________________________________________________
Purchaser _____________________________________________________________
Dealer Address _____________________________________________________________
Installer's Name _____________________________________________________________
Installer's Signature _____________________________________________________________
Installation Company _____________________________________________________________
Installation Date _____________________________________________________________

FINAL CHECKLIST

Packaging: Ensure all internal and external packaging has been removed. Refer to 'Before
F
installation', page 27.
Fault codes: Ensure no error codes are shown.
F
Installation mode: Ensure the Installation Mode is de-activated (hold on Compartment
F
button for 4 sec. Refer to 'Power and water supply connection', page 35.
User guide: Check the User Guide is inside the product in a visible area for the customer.
F
FOR PRODUCTS WITH WATER ONLY OR ICE AND WATER FUNCTION
F Water filter: Water filter is installed and engaged in a horizontal position. Refer to 'Install
water filter', page 39.
F Ice maker: Turn ice maker ON. Force a manual ice maker cycle by pressing the
(alarm symbol), - & + buttons together for 4 seconds then close the door(s). The ice tray
will fill and empty into the bin below, dry the bin and return it correctly. Refer to page 19
of your User Guide.
F Dispenser: Ensure the water is flowing through the system using the dispenser pad. Refer
to page 18 of your User Guide.
63