Table of Contents
Advertisement
Move the sensor housing
1
Unclip the hall sensor
from the housing.
Unhook the interceptor
2
board harness from
sensor housing so
harness is loose.
Remove the #8x16
3
screws (2x) from the
sensor housing.
60
60
CHANGE THE DOOR HINGES (OPTIONAL)
Move the sensor housing
4
to align the opposite hall
sensor clip with the centre
of the cabinet.
Reinstall the sensor housing
5
using #8x16 screws (2x)
into the pre-drilled holes in
the cabinet top panel.
Clip the hall sensor into
6
the sensor housing in
F
the pocket closest to the
centreline of the cabinet.
Press the harness from the
7
interceptor board into the
forks on the sensor housing.
Advertisement
Table of Contents
