Table of Contents
Advertisement
Installation kit
Attaching the long glass trims
Glass trims are attached to cover the gap between the Stainless steel door panel and glass panel.
Long trim (2x)
Tools
1
Cutter
DOOR PANEL PREPARATION — WINE CABINET ONLY
long trim
red protective film
Peel off a small portion of red
protective film from one end of
the long trim.
2
3
Cut excess length of
trim along this line
Illustrations may differ from your purchased appliance.
hanging bracket
Do not exceed
past this line
long trim
Attach the peeled portion of the trim
starting from the top of the flange on
one side of the door panel cutout.
Ensure the trim does not overlap
the hanging bracket.
Align the trim flush with inside edge
of the flange.
flange
Continue attaching the long trim for
the length of the door panel cutout,
peeling off the film as you go.
Cut-off the excess length of the
bottom end of the long trim.
Repeat all steps on the other side of
door panel cutout.
35
Advertisement
Table of Contents
