Technical Specifications And Main Parts; Installing The Ek-Quantum Scalar 2 Direct Link Side Port Terminal - EK Quantum Scalar2 Direct Link Side Port Terminal - Acetal User Manual

TECHNICAL SPECIFICATIONS AND MAIN PARTS

1
4
INSTALLING THE EK-Quantum Scalar
FC TERMINAL
O-RINGS
14 x 1 mm
M4 x 20 DIN7984 SCREW
TERMINAL BADGE
3
2
5
DO NOT REMOVE
TWO (2) MARKED
O-RINGS.
FC TERMINAL WITH SIDE COVER
STEP 1
Product dimensions: 72 x 39.5 x 19 mm
Position Code Name
1 105909 Terminal Base (Ni)
2 105907 Terminal - Block (Acetal)
3 104216 Disc magnet 3 x 3
4 8208 Screw M3 x 8 7991DIN
5 5008 OR 52 x 1.5 mm
Direct Link Side Port Terminal
2
Important! Before starting, make sure to have a clean, flat surface
to work on. It is recommended to put foam or soft material to lay
the graphics card on. If the water block is filled with liquid, make
sure to drain it before installing the Side Port Terminal.
STEP 1
Detach two (2) terminal badges (the terminal badge is attached with
two (2) magnets)). Unscrew the pre-installed terminal together with the
side cover and two (2) Terminal O-rings from the water block using the
Allen Key 2.5 mm. Save the parts for later use.
DO NOT REMOVE TWO (2) MARKED O-RINGS.
For this step, you will need:
Allen Key 2.5mm
- 6 -
Quantity
1
1
4
3
1