Summary of Contents for EK EK-Mana MSI MAG Z690 TORPEDO EK X D-RGB
Page 1
EK-Mana MSI MAG Z690 TORPEDO EK X D-RGB MONOBLOCK USER GUIDE...
Page 2
CPU and/or motherboard’s circuit board (PCB). The EK- Fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.
TABLE OF CONTENT BOX CONTENTS PREPARING YOUR MOTHERBOARD APPLYING THERMAL COMPOUND CUTTING THERMAL PADS PLACING THERMAL PADS ON THE MONOBLOCK PLACING THE BLOCK ON TO MOTHERBOARD ATTACHING BLOCK ON THE MOTHERBOARD TECHNICAL SPECIFICATIONS AND WATER BLOCK PARTS CONNECTING THE D-RGB LED STRIP REQUIRED TOOLS SUPPORT AND SERVICE SOCIAL MEDIA...
APPLYING THERMAL COMPOUND Apply thermal compound on CPU heat spreader (IHS) with enclosed EK-TIM Ectotherm thermal grease. The quantity of about two rice grains is just about right. There is no need to cover the whole IHS. Applying too much thermal grease will have negative impact on the...
Use four (4) M4 PVC washers and Magnitude Z690 Torpedo Standoff (Ni) STANDOFF and screw them into the motherboard. Place the EK-Mana MSI MAG Z690 TORPEDO EK X D-RGB water block to the motherboard (as shown on the photo). Make sure that mounting holes are aligned.
CONNECTING THE D-RGB LED STRIP Plug the 3-pin connector from Monoblock D-RGB LED strip to the motherboard. Please ensure that the arrow indicated on the connector is plugged into the +5V line as indicated on your motherboard. Failure to do so will damage your motherboard or LED strip. D-RGB HEADER RGB HEADER STEP 1...
SPECIFICATIONS AND PRODUCT PARTS” where you can find the EAN number of each part you might need. Include the EAN number with quantity in your request. Mounting Mechanism EAN can be found under “BOX CONTENTS” Thermal pads are readily available in the EK shop SOCIAL MEDIA EKWaterBlocks @EKWaterBlocks...