Auping Smart Base Quick Start Manual page 2

Discover the new remote control
Operate the bed
Use the top row of buttons to move the adjustable
sections up.
Use the large button at the top to move all
sections upwards at the same time.
Use the large button at the bottom to move all
sections downwards at the same time.
Use the bottom row of buttons to move the
adjustable sections down.
Operate both bed sides
You can also control your partner's half of the bed
using the same remote control. Press and hold the
outer buttons for 3 seconds to change bed sides.
The remote control switches from bed side A to bed
side B and then to A and B together. This allows you
to control both bed sides at the same time. This
mode is not visible on the remote, but you can test it
by operating the bed.
Preferred positions
You can programme three preferred modes using the
remote control. Once you have found the position
you want to save, press and hold 1 of the 3 buttons
for 3 seconds. If you have saved several favourite
positions, you can switch between your favourite
positions by tapping the button once. Preferred
positions can be reset at any time.
LED colour display
The new remote control provides guidance in daily use via a LED colour display behind the
buttons. You may see the following colours:
Blue: If the remote control is not yet paired, the LED screen flashes blue. When the remote
control is paired with a Smart Base, the LED screen turns solid blue.
White: When the remote control is in active mode, the LED screen turns white..
Pair mode
This button puts the remote control in pair mode.
Press and hold the button for 3 seconds until the
lights flash blue 3 times
Child lock
Press this button to activate the child lock. Press and
hold the button for 2 seconds to turn it on or off.
Green: When you programme a preferred position or change the bed side, the LED screen
flashes green 3 times.
Orange: If the remote control's child lock is turned on, the LED screen turns orange when a
button is pressed.