Table of Contents
Advertisement
3. Locate the outer rails on the frames of the rack.
NOTES:
Check the installation direction of the rack rail.
There are some angle holes for screw driving on the
supports of the rack. Locate the rack rail so that the
portion of the narrower distance between the front
and rear angle holes is placed at the center of the
rack rail. For any NEC rack, round stamps are put in
the unit of 1U. Locate the rack rail so that a stamp is
placed at the center of the outer rail.
If the depth of the rack is not enough, remove the two screws at the tip to extend
the slide bracket. ※Attach the screws which removed to the position of the figure.
Two round stamps
(located at 5U position)
Stamp
Narrower distance
between angle holes
- 15 -
Advertisement
Table of Contents
