ZyXEL Communications Omni TA128 User Manual page 93

Chapter 16 - AT Command Set Reference
Command Options Function & Description
&Hn
&H0
&H3 *
&H4
&Jn
&J0 *
&J1
&J2
&J3
&Knn
&K00
&K44
&Ln
&L0
&L1
&On
&O0
&O2
&O3
&Sn
&S0 *
&S1
&Tn
&T9
&T10
&Vn
&V0
&V1-4
&V5
&V6
&V7
&Wn n=0-3
&Z?
Data flow control, DTE/DCE.
Flow control disabled.
Hardware (CTS/RTS) flow control
Software (XON/XOFF) flow control.
Bundle selection (See also S100)
Bundle connection is disabled
Bundle connection is enabled in answer
mode only
Bundle connection is enabled in call mode
only
Bundle connection is enabled in both
directions
V.120/X.75 compression control.
&K must be followed by two digits.
Disable V.42bis
Enable V.42bis
Analog port selection during call answering
Set priority to analog port, Phone 1
Set priority to analog port, Phone 2
Set default call type for conventional dialing
commands
ATDs, ATDPs, and ATDTs default to
make calls for analog adapter, Phone 2
ATDs, ATDPs, and ATDTs default to
make ISDN data calls
ATDs, ATDPs, and ATDTs default to
make calls for the analog adapter, Phone 1
Data Set Ready (DSR) function selection.
DSR overridden, DSR always ON.
DSR according to CCITT (ITU-TSS). (See
also S41.5, S44.4)
TA testing.
Initiate ISDN Loopback test
Initiate ISDN Loopback with self test
View profile settings.
View current active settings.
View the (n-1)th user profile settings
View factory default settings.
View analog adapter, Phone 1 setting
View analog adapter, Phone 2 setting
Write current settings to user profile n in
non-volatile RAM. (See also S35.6)
Display all the phone numbers stored in
non-volatile RAM.
16-8
Ref.
S27.3-5
S87.5-6
S83.2
S84.5
S83.4-5
S21.3