ZyXEL Communications Omni TA128 User Manual page 105

Chapter 17 - Status Registers and Result Codes
Command bit
S117=
S118= bit
0
2
4
5
6
7
S119= bit
0
1
2
3
4
5
dec hex Function and description
V.110 user rate
dec hex
0 0 Enable dial-in call
1 1 Disable dial-in call (dial out only)
0 0 Default B channel line speed is 64Kbps for
ISDN data call
4 4 Default B channel line speed is 56Kbps for
ISDN data call
0 * 0 Use 3.1KHz Bearer service whenever
possible for analog adapter, Phone 2
16 10 Use Speech Bearer service whenever
possible for analog adapter, Phone 2
0 * 0 Use 3.1KHz Bearer service whenever
possible for analog adapter, Phone 1
32 20 Use Speech Bearer service whenever
possible for analog adapter, Phone 1
0 * 0 Enable analog adapter to accept global
calls
64 40 Forbid the analog adapter to accept global
calls with MSN unmatched
(see AT&ZIn=s)
0 * 0 Enable analog incoming calls
128 80 Reject analog incoming calls
dec hex
0 * 0 Disable call-back function
1 1 Enable call-back function
0 * 0 Disable point-to-point signaling DDI
function
2 2 Enable point-to-point signaling DDI
function
0 * 0 Disable point-to-multipoint signaling DDI
function
4 4 Enable point-to-multipoint signaling DDI
function
0 * 0 Inbound call ignored when no MSN (EAZ)
is matched
8 8 Inbound call accepted using default
protocol when no MSN (EAZ) is matched
0 * 0 V.110 user rate = 19200 bps if DTE
speed greater than 19200 bps
16 10 V.110 user rate = 38400 bps if DTE
speed greater than 38400 bps
0 * 0 Enable normal MSN function
32 20 Treat the number assigned by &ZI=n... as
sub-address, and match with the
called_party_subaddress for inbound call
routing
17-10
Ref.
B1n
&E0
&E1
*GC
&ZIn