Full Spectrum Laser MUSE CORE User Manual
  1. Manuals
  2. Brands
  3. Full Spectrum Laser Manuals
  4. Cutter
  5. Muse
  6. User manual

Full Spectrum Laser MUSE CORE User Manual

Hide thumbs Also See for MUSE CORE:
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MUSE CORE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Full Spectrum Laser MUSE CORE

Summary of Contents for Full Spectrum Laser MUSE CORE

  • Page 2: Safety Warning

    Safety Warning: Diagrams: Do not leave your machine unattended. Water Exhaust In/out Power Switch Avoid using machines made of carbon or that contain carbon components. Always keep a fire extinguisher and first aid kit nearby. Do not attempt to access any electrical areas while the machine is on.
  • Page 3 Remove Zip Ties. 1. Cut open the box. Connect the exhaust ducting to the exhaust.. 3. Pull out the Muse Core. 2. Take out the Honeycomb tray. Connect to the exhaust fan. 4. Carefully remove Box 1 and 2 from the machine.
  • Page 4 Hobby Kit Only Coolbox Only Get a bucket and fill it with two and a half gallons of distilled water. Pull out the water pump and place its plastic fitting on. Get the two water tubes. Connect the first one to the Water Out 4.

  • Page 5: Connecting To Internet

    Connecting to Internet: Focusing: Connect Via Router (Recommended): To begin, choose your desired material and retrieve the provided billet. To establish a reliable link to RE3, it is recommended to connect the Fiber Galvo to the router. The Fiber Galvo is equipped with an ethernet cable that should be plugged into the ethernet ports of both devices Note: Ethernet port looks the same on all devices Next, either access RE3 or use the Touchscreen to maneuver the laser head into...

  • Page 6: Touchscreen Interface

    Touchscreen Interface: Home The Home screen displays important information such as the device's Network ⇨ Wi-Fi IP address, the QR Code for RE3, and controls for the laser head. Enables users to connect to a Wi-Fi network. Job History The Job History icon provides easy access to previous projects. Mobile Version Users can select the file and view its contents, or choose to re-run the A mobile version of the device is accessible by either scanning...

  • Page 7: Belt Replacement

    Belt Replacement: X-Belt Replacement: Y-Belt Replacement: Power Off and Unplug Machine. Power Off and Unplug Machine. Locate the Belt Screws. The belt can be found above the adjustment knob. Adjust the Locate the Belt Screws. The belt is under the gantry (see below). Adjust the gantry as necessary to access the screws.

  • Page 8: Lens Replacement

    Air Assist Cone Replacement: Lens Replacement: Please Note: The Air Assist Cone must be replaced when the lens is switched. Disconnect the air hose by gently removing each end. Remove the lens by push the back of the lens until you hear a click. Then, simply slide Using a 1.5 hex wrench (not included) to loosen the “set”...

  • Page 9: Troubleshooting

    Project Procedure: Troubleshooting: Q: What could be causing my laser to not mark? Connect to Software A: It is possible that your laser is out of focus. If the height of the machine is off by a few millimeters, it may not engrave properly.

Table of Contents