Fröling Turbomat 320 Operating Instructions Manual

Wood chip boiler

Hide thumbs Also See for Turbomat 320:

Operating instructions manual (31 pages)

Service handbook (116 pages)

Table Of Contents

Table of Contents

Table of Contents
General
Product Overview
Safety
Hazard Levels of Warnings
Pictograms Used
General Safety Information
Permitted Uses
The Clean Air Act 1993 and Smoke Control Areas
Permitted Fuels
Wood Chips
Wood Pellets
Wood Shavings
Miscanthus
Changing the Fuel
Non-Permitted Fuels
Qualification of Operating Staff
Protective Equipment for Operating Staff
Safety Devices
External Safety Devices
Hydraulic Chamber Safety Switch
Guardrail
Residual Risks
Emergency Procedure
Overheating of the System
Smell of Flue Gas
Fire in the System
Notes for Operating a Heating System
Installation and Approval of the Heating System
General Information for Installation Room (Boiler Room)
Requirements for Central Heating Water
Notes for Using Pressure Maintenance Systems
Return Lift
Use with Storage Tank
Chimney Connection/Chimney System
Operating the System Assembly and Initial Startup
Filling the Store Space with Fuel
Loading of Fuel for a Partially Emptied Store with Rotary Agitator
Loading Fuel in an Empty Store Space with a Rotary Agitator
Rotary Agitator with Combined Drive System
Rotary Agitator with Separate Drive System (Optional)
Blowing in Fuel for a Partially Emptied Store with Rotary Agitator
Blowing in Fuel for an Empty Store with Rotary Agitator
Rotary Agitator with Combined Drive System
Rotary Agitator with Separate Drive System (Optional)
Blowing in Pellets for a Store with Pellet Screw
Loading Fuel in a Store Space with a Sliding Floor Discharge Unit
Loading Fuel in a Store Space with a Horizontal Screw Discharge Unit
Loading Fuel in a Store Space with an Inclined Screw Discharge Unit
Drainage of Fuel Store
Heating up the Boiler
Switching on the Power Supply
Switching on the Boiler
Regulating the Boiler
Switching off the Boiler
Switching off the Power Supply
Servicing the System
General Information on Servicing
Required Tools
Maintenance Work by the Operator
Inspection
Checking the System Pressure
Checking the Thermal Discharge Safety Device
Checking the Safety Valve
Checking the Geared Motors
Checking the Quick Vent Valve
Checking the Draught Controller Flap
General Weekly Inspection
Cleaning
Emptying the Combustion Chamber Ash Container
Emptying the Ash Container in the Heat Exchanger
Cleaning the Combustion and Burning Chamber
Periodic Inspection and Cleaning
Periodic Inspection and Cleaning (Approx. 1,000 Hrs)
Cleaning the Ash from the Heat Exchanger
Cleaning the Flue Gas Temperature Sensor
Cleaning the Heat Exchanger
Cleaning the Flue Gas Recirculation (FGR) Duct
Lubricate the Stoker Bearings
Cleaning the Area under the Moving Grate
Periodic Inspection and Cleaning (Approx. 3,000 Hrs)
Cleaning the Fireclay Elements
Setting and Checking the Seal on the Doors
Adjusting the Doors
Cleaning the FGR Blower Fan
Cleaning the Induced Draught Fan
Checking the Heat Exchanger Ash Removal Drive
Check the Igniter Tube
Cleaning the Secondary Air Duct
Checking the Underpressure Controller
Cleaning the Combustion Air Blower Fan
Checking the Combustion Chamber Overpressure Sensor
Lubricating the Bearings
Checking the Flue Gas Pipe
Maintenance Work by Technicians
Cleaning the Lambda Probe
Maintenance Instructions for Hydraulic System
Emissions Measurement by Chimney Sweep or Regulatory Body
Switch on the System
Start Emissions Measurement
Replacement Parts
Disposal Information
Disposal of the Ash
Disposal of System Components
Troubleshooting
General Faults in the Power Supply
Behaviour of System after a Power Failure
Excessive Temperature
Faults with Fault Message
Procedure for Fault Messages
Notes
Appendix Addresses
Address of Manufacturer
Customer Service
Address of the Installer

Quick Links

Download this manual

Operating Instructions

Turbomat TM 320 - 550

Translation of the original German operating instructions for operators

Read and follow the instructions and safety information!

Technical changes, typographical errors and omissions reserved!

B0340720_en | Edition 16/03/2020

Fröling GesmbH | A-4710 Grieskirchen, Industriestraße 12 | www.froeling.com

Table of Contents

Need help?

Do you have a question about the Turbomat 320 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Turbomat 400 Turbomat 500 Turbomat 550Tm 320Tm 400 Tm 500 ... Show all

Fröling Turbomat 320 Operating Instructions Manual

Quick Links

Need help?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Fröling Turbomat 320

This manual is also suitable for:

Table of Contents