Signature Capture Optimize - Honeywell Vuquest 3320g User Manual

Signature Capture Optimize

If you will be using your scanner to capture signatures frequently, you should
optimize it for this purpose. However, the speed of scanning barcodes may be
slowed when this mode is enabled. Default = Off.
Optimize On
Below is an example of a signature capture application. In this example, the aimer
is centered over the signature capture area and the button is pushed. A single beep
is emitted, indicating that the scanner has read a Code 128 barcode and the data
has been transferred to the host. An IMGBOX command may now be sent from the
host to specify the coordinates of the signature capture area below that code, and
indicating that only that area containing the signature should be transferred as an
image to the host.
To see this example, align the aimer with the signature area (not with the barcode),
then push the button.
Send the following IMGBOX command string after the button push:
Example: IMGBOX245w37h55y.
Note: Case is not important in the command string. It is used here only for clarity.
The following image is captured:
Vuquest 3320g User Guide
* Optimize Off
163