LED Illumination - Presentation Mode
If you wish to set the LED illumination brightness, scan one of the barcodes below.
This sets the LED illumination for the scanner when it is in Presentation Mode. If
the scanner is triggered manually, the LED illumination will switch to the setting
for a manual trigger. (See
Default = High.
Note: This command is not supported by the Gen 7 software revision. For scanners with the
Gen 7 revision, use
Presentation Mode and Manual Mode. For infomation about software revisions, see
About Software Revisions
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the
brighter the LEDs need to be so the scanner can "see" the barcodes.
Off
* High
Note: LED Illumination - Presentation Mode does not apply to
Mode
Presentation LED Behavior after Decode
When a scanner is in presentation mode, the LEDs dim 30 seconds after a barcode
is decoded. If you wish to dim the LEDs immediately after a barcode is decoded,
scan the LEDs Off barcode, below. Default = LEDs On.
* LEDs On
Vuquest 3320g User Guide
LED Illumination - Manual Trigger
or
Mobile Phone Read
LED Illumination - Manual Trigger
on page 6.
Mode.
on page 38.)
on page 38 for both
Low
Streaming Presentation™
LEDs Off
41