Related Manuals for Nibe DRAZICE NADO 800/35v9
Summary of Contents for Nibe DRAZICE NADO 800/35v9
- Page 1 OPERATING AND INSTALLATION MANUAL STORAGE TANKS NADO 800/35v9 NADO 1000/35v9 Družstevní závody Dražice-strojírna s.r.o. Dražice 69, 294 71 Benátky nad Jizerou tel.: +420 / 326 370 911 fax: +420 / 326 370 980 e-mail: export@dzd.cz...
-
Page 2: Table Of Contents
CONTENTS FUNCTION DESCRIPTION ........................... 4 THE DESIGN OF SUITABLE VOLUME AND TANK INSTALLATION ..............4 TECHNICAL PARAMETERS .......................... 5 IMPORTANT WARNING ..........................6 TECHNICAL DESCRIPTION .......................... 7 DIMENSIONS AND CONNECTION ......................8 DISPOSAL OF PACKAGING MATERIAL AND NON-FUNCTIONING PRODUCT..........9 - 2 -... - Page 3 CAREFULLY READ THIS MANUAL BEFORE INSTALLING THE TANK! Dear Customer, The Works Cooperative of Dražice - Machine Plant, Ltd., would like to thank you for your decision to use a product of our brand. The product is not intended to be controlled by a) people (including children) with reduced physical, sensual or mental capacities, or b) people with insufficient knowledge and experiences unless supervised by responsible person, or unless properly instructed by such responsible person.
-
Page 4: Function Description
1 FUNCTION DESCRIPTION Storage tanks serve accumulation of excessive heat from its source. The source may be a solid fuel boiler, heat pump, solar collectors, fireplace inserts, etc. The NADO type storage tanks serve accumulation of heat in the heating system and allow heating or preheating of HSW (Hot Service Water) in an inner stainless tank. -
Page 5: Technical Parameters
3 TECHNICAL PARAMETERS NADO 800/35v9 NADO 1000/35v9 STORAGE TANK CAPACITY CAPACITY OF STAINLESS EXCHANGE CAPACITY OF BOTTOM EXCHANGER CAPACITY OF UPPER EXCHANGER WEIGHT HEATING SURFACE OF STAINLESS EXCHANGE HEATING SURFACE OF BOTTOM EXCHANGE HEATING SURFACE OF UPPER EXCHANGE MAXIMUM TANK PRESSURE MAXIMUM PRESSURE OF STAINLESS EXCHANGER MAXIMUM PRESSURE OF BOTTOM AND... -
Page 6: Important Warning
4 IMPORTANT WARNING Connection of internal tank for hot water must comply with CSN 060830, i.e. on cold water inlet is necessary to install a safety valve. We recommend to start up the heating circle before commissioning and to clean possible dirts caught in the filter and after this the system would be fully functional. -
Page 7: Technical Description
5 TECHNICAL DESCRIPTION Figure 1 1. Bleeding (heating water outlet) - G1" 2. Hot service water outlet - G 1 ¼" 3. Steel receptacle 4. Exchanger for connecting an additional heating source 5. Funnel for additional heating element TJ 6/4 - G 1 ½" (2 units) 6. -
Page 8: Dimensions And Connection
6 DIMENSIONS AND CONNECTION NADO 800/35v9, NADO 1000/35v9 NADO 800/35v9 NADO 1000/35v9 1027 1117 1400 1530 Figure 2 1607 1897 1820 2120 1037 1123 1202 1950 2250 1990 2285 1560 1862 1" outer 1 1/4" outer 1 1/2" inner 1200 1340 ... -
Page 9: Disposal Of Packaging Material And Non-Functioning Product
Thermal insulation NEODUL LB PP Insulation NEODUL of 80 mm thickness. It consists of an upper cover, flange cover and hole caps. Insulation is supplied in a separate packaging. We recommend that the insulation was fitted at room temperature. At temperatures significantly below 20 °C the insulation shrinks.