Table of Contents
Advertisement
SuperIO Device
Press <Enter> to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Enable the onboard floppy controller. Select "Enabled" when you have
installed a floppy disk drive. Settings: Enabled and Disabled.
Onboard Serial Port 1/2
Set the base I/O port address and IRQ for the onboard serial port A/serial
port B. Selecting Auto allows BIOS to automatically determine the correct
base I/O port address. Settings: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/
IRQ4, 2E8/IRQ3 and Auto.
Serial 2 Mode Select
The field specifies the operation mode for serial port "COM B". If the mode
selected is not "Serial Port" then "COM B" will be disabled in order for other
device to take effect. Settings are:
Serial Port:
IrDA(Infrared):
ASKIR(Infrared):
SmartCard Reader: SmartCard Reader
UR2 Duplex Mode
Set the operating mode of IR transmission/reception. Under Full Duplex
RS-232C Serial Port
IrDA-compliant Serial Infrared Port
Amplitude Shift Keyed Infrared Port
3-15
BIOS Setup
Advertisement
Table of Contents
