Table of Contents
Advertisement
Motion
Virtual Trigger
Physical Trigger
Note – Please refer the Hardware Installation of P
wiring of motion in position signal output to MAVI
Selected the active polarity mode
and user can refer 1.4.9 for Strobe
Control polarity definition.
Setting
necessary
1.4.9.for the formula of delay time.
Setting the strobe duration and
time base and please refer 1.4.9
for the formula of duration time.
Enable the check box while used
FRNET for I/O trigger simulation.
Selected the output port of FRNET
and ensure the wiring correctly.
Setting the trigger pulse frequency
of FRNET.
ISO-PS400 or E
S trigger input port.
Enable the check box while used
PISO-PS400 or ET-M8194H for
received the in position signal from
encoder / sensor.
Enable the check box of Trigger
Compare and setting the Total
Pulse
equidistance trigger.
Enable the check box while active
the trigger pulse i n randomized.
- 49 -
the
delay
value
and
please
T-M8194H for the
and
Trigger
Pitch
in
refer
for
Advertisement
Table of Contents
