Table of Contents
Advertisement
SINCLAIR
Running Parameters for Commissioning of Household Air Source Heat Pump Water Heaters
Project name:
Commissioning performed by:
Rated capacity of the outdoor unit
(kW)
Maximum drop between the
outdoor unit and water tank (m)
Status Parameter
Status parameters of the outdoor
unit
Parameters of the water tank
Summary
6 Unit Function Setting
On the main interface, press the TIMER button for 5 second. The system time setting interface is
displayed. The time icon is on and the hour value flickers. Press ▲ or ▼ to adjust the hour value and
press the TIMER button to confirm setting. Then the minute value flicks. Press ▲ or ▼ to adjust the
minute value and press the TIMER button to confirm setting. After system time setting is saved, the main
interface is displayed. During the setting process, if no button is pressed within 15 second, the main
interface will be displayed and setting will not be saved.
The system time ranges from 00:00 to 23:59. Upon each press of ▲ or ▼ button, the time increases
or decreases by 1 hour or 1 minute. When the button is pressed steadily, the time increases or
decreases continuously by 1 hour or 1 minute.
The setting process is shown in the following figure.
Press the TIMER button
Main interface
steadily
NOTES: The other functions setting refer to wired controller instructions of the unit.
AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
Commissioning status:
Outdoor ambient
temperature
Power supply voltage
Air intake temperature
Air exhaust temperature
Temperature of the
temperature sensor for
water outlet pipe
Temperature of the water
temperature sensor
System time
Press the TIMER
hour value flickers
button
50
Water tank model:
Capacity of
the water
tank
Length of system pipe
□ Heat up
Unit
Before Startup
°C
V
°C
°C
°C
°C
System time
Press the TIMER
minute value
flickers
Unit model:
Date
60 minutes
Setting is
button
complete.
Advertisement
Table of Contents
