Table of Contents
Advertisement
SINCLAIR
In the E-HEATER mode, users can press the MODE button to switch to the HOTWATER mode.
Note that the E-HEATER mode will be cancelled automatically and the HOTWATER mode will be started
upon restart of the water heater in the case of blackout.
4.4 Water Temperature Setting
In the On state, press "▲" to increase or press "▼" to decrease the temperature set point. The water
temperature will increase or decrease continuously by 1°C when the button is pressed and held.
The minimum temperature set point for all models is 35°C. The maximum temperature set point can
be set to 55°C, 58°C, or 70°C. For details, see the Integrated Unit User Manual.
4.5 Time Setting
4.5.1 System Time Setting
In the main interface, press and hold the TIMER button for five second. The system time setting
interface is displayed. The clock icon is on and the hour value blinks. Press "▲" or "▼" to adjust the hour
value and press the TIMER button to confirm setting. Then the minute value flickers. Press "▲" or "▼" to
adjust the minute value and press the TIMER button to confirm setting. After system time setting is saved,
the main interface is displayed. In the setting process, if no button is pressed within 15s, the main
interface will be displayed and setting will not be saved.
The system time ranges from 00:00 to 23:59. Each time you press "▲" or "▼", the time increases or
decreases by 1 hour or 1 minute. When the button is pressed and held, the time increases or decreases
continuously by 1°C or 1 minute.
The setting process is shown in the following figure.
Press and hold the
Main interface
TIMER button.
AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
Hour value of the
Press the TIMER
system time
button.
blinks.
10
Minute value of
Press the TIMER
the system time
button.
blinks.
Setting is
complete.
Advertisement
Table of Contents
