Function Setting - Sinclair SWH-200DE Service And Installation Manual

SINCLAIR
Main interface
The minute
value of
PRESET X
blinks.
Setting is
complete and
PRESET X is
started.
The PRESET mode runs circularly. The water heater starts to heat up water based on the preset
time and ambient temperature and stops one hour after the preset time.

4.6 Function Setting

4.6.1 i-know
In the On state, press the i-know button to select the i-know function. To cancel this function, press
the i-know button again.
4.6.2 RAPID
In the On state, press the RAPID button to select the RAPID function. The electrical heater is started
for heat up. To cancel this function, press the RAPID button again. Then electrical heater is stopped.
Under the E-HEATER mode, users can press the RAPID button to switch to the HOTWATER mode.
To return to the E-HEATER mode, press the RAPID button again.
4.6.3 CYCLE, SUNFLOWER, ABSENCE, and ONCE
In the On state, press the FUNCTION button to enter the interface for selecting among the CYCLE,
SUNFLOWER, ABSENCE, and ONCE functions. When a function is selected, the corresponding icon
AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
Press the PRESET 1
TIMER button. blinks.
The hour value
Press the
of PRESET X
TIMER button.
blinks.
13
PRESET 1 or
Press ▲ or ▼ to select
PRESET 3
PRESET X
The ON icon
Press the TIMER button.
The OFF icon
Setting is complete
and PRESET X is
canceled.
blinks.
blinks.
blinks.