Installation Of Water Tank - Sinclair SWH-200DE Service And Installation Manual

SINCLAIR

3.2 Installation of Water Tank

3.2.1 Overall Dimensions and Size of Installation Holes
External Dimensions and Installation & Maintenance Space of SWH-200DE
3.2.2 Requirements on Installation Position and Space
(1) The water tank suggest be installed indoors. When be installed outdoors, it need a shed or
mantle to prevent rain. In addition , the water tank and safety valve shall not be installed inside the room
or balcony which is without discharge floor drain.
(2) Try to install it in an environment where the temperature is higher than 0°C. The hot water outlet
should not be too far away from the locations for use. Lay out the pipes in a centralized manner, and take
thermal insulation measures on hot water piping to reduce heat loss.
(3) The water tank must be placed upright with all feet touching the ground. It must be installed on
a solid foundation. During water tank installation, consider the weight bearing capability of the foundation.
The following figure shows the installation diagram.
NOTE: The water tank must also be fastened to the wall using a tank mounting hoop or plate to
prevent fall-off the water tank due to exceptions.
AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
Parameter
D
H
F
E
Cool water inlet (internal thread)
Hot water outlet (internal thread)
Working medium inlet (internal thread)
Working medium outlet (internal thread)
26
462
2000
1797
166
G1/2
G1/2
Φ9.52
Φ6