Communication Cable Connection; Installation And Disassembly Of Wired Controller - Sinclair SWH-200DE Service And Installation Manual

SINCLAIR

7.2 Communication Cable Connection

7.2.1 Communication Cable Connection for Vertical Model
The water tank does not need to communicate with the outdoor unit. Therefore, connect the
communication cable led out from the outdoor unit to the wired controller.
7.2.2 Communication Cable Connection for Wall-mounted Model
The water tank needs to communicate with the outdoor unit. Therefore, connect the communication
cable led out from the water tank to the communication cable interface of the outdoor unit.

7.3 Installation and Disassembly of Wired Controller

7.3.1 Requirements for Wired Controller Installation Locations
(1) Do not install the wired controller in a wet place or a place exposed to direct sunlight.
(2) Do not install the unit or wired controller of the air source water heater in a place susceptible to
electromagnetic interference.
(3) Ensure that the communication line is connected to the correct interface. Otherwise,
communication will be failure.
7.3.2 Wired Controller Installation
No.
Front panel of wired
Name
AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
1
controller
Figure 7-1 Accessories of Wired Controller
Figure 7-2 Installation Diagram of Wired Controller
2
Screw Soleplate of controller
39
3 4
Socket's base box
installed in the wall