Common Modes Setting; Special Modes Setting - Sinclair SWH-200DE Service And Installation Manual

SINCLAIR

4.2 Common Modes Setting

In the On state of the unit, press the MODE button to switch the operation modes in the following
sequence:
The HOTWATER mode is shown in the following figure.

4.3 Special Modes Setting

If the heat pump of a water heater equipped with an electrical heater is faulty, users can press and
hold MODE+RAPID for 5s in any mode under the state to enter the E-HEATER mode.
NOTE: The E-HEATER mode can be used only when the heat pump is faulty. In this case, contact
the aftersales service immediately.
The E-HEATER mode is shown in the following figure.
AIR SOURCE HEAT PUMP WATER HEATER SERVICE MANUAL
HOTWATER SAVE
PRESET
NIGHT
9