Dimm Installation Sequence; Memory Mirroring - Lenovo ThinkServer RD220 3797 Series Installation And User Manual

DIMM installation sequence

The server requires at least one DIMM per microprocessor. The server comes with
a minimum of two 1 GB DIMMs, installed in connectors 3 and 6. (Connectors 3 and
6 are the farthest connectors for channels 0 and 1 of microprocessor 1.) When you
install additional DIMMs, install them in the order shown in Table 8, to maintain
performance.
Important: If you have configured the server to use memory mirroring, do not use
the order in Table 8; go to "Memory mirroring" and use the installation order shown
there.

Memory mirroring

Memory-mirroring mode replicates and stores data on two pairs of DIMMs within
two channels simultaneously. If a failure occurs, the memory controller switches
from the primary pair of memory DIMMs to the backup pair of DIMMs. You must
enable memory mirroring through the Setup utility. For details about enabling
memory mirroring, see "Using the Setup Utility program" on page 104. When you
use the memory mirroring feature, consider the following information:
v When you use memory mirroring, you must install a pair of DIMMs at a time.
v Channel 2, DIMM connectors 8 ,7, 15, and 16 are not used in memory-mirroring
v The maximum available memory is reduced to half of the installed memory when
The following illustration shows the memory channel interface layout with the DIMM
installation sequence for mirroring mode. The numbers within the boxes indicate the
DIMM population sequence in pairs within the channels, and the numbers next to
the boxes indicate the DIMM connectors within the channels. For example, the
following illustration shows that the first pair of DIMMs (indicated by ones (1) inside
the boxes) should be installed in DIMM connector 3 on channel 0 and DIMM
connector 6 on channel 1. DIMM connectors 7, 8, 15, and 16 on channel 2 are not
used in memory-mirroring mode.
66
ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide
Table 8. DIMM installation sequence for non-mirroring (normal) mode
Installed microprocessors
Microprocessor socket 1
Microprocessor socket 2
One DIMM must be in channel 0, and the mirroring DIMM must be in the same
connector in channel 1. The two DIMMs in each pair must be identical in size,
type, rank (single, dual, or quad), and organization. They do not have to be
identical in speed. The channels run at the speed of the slowest DIMM in any of
the channels. See Table 10 on page 68 for the DIMM connectors that are in each
pair.
mode.
memory mirroring is enabled. For example, if you install 64 GB of memory, only
32 GB of addressable memory is available when you use memory mirroring.
DIMM connector population sequence
Install the DIMMs in the following sequence: 3, 6, 8, 2, 5, 7,
1, 4
Install the DIMMs in the following sequence: 11, 14, 16, 10,
13, 15, 9, 12