Lenovo ThinkServer RD220 3797 Series Installation And User Manual page 104

v All hot-swap drives in the server should have the same throughput speed rating.
v The ID that is assigned to each bay is printed on the front of the server above
Important: Do not install a SCSI hard disk drive in this server.
To install a drive in a hot-swap bay, complete the following steps.
Attention:
than 10 minutes without either a drive or a filler panel installed in each bay.
1. Orient the drive as shown in the illustration.
2. Make sure that the tray handle is open.
3. Align the drive assembly with the guide rails in the bay.
4. Gently push the drive assembly into the bay until the drive stops.
5. Push the tray handle to the closed (locked) position.
6. If the system is turned on, check the hard disk drive status LED to verify that
After you replace a failed hard disk drive, the green activity LED flashes as the disk
spins up. The amber LED turns off after approximately 1 minute. If the new drive
starts to rebuild, the amber LED flashes slowly, and the green activity LED remains
lit during the rebuild process. If the amber LED remains lit, see "Hard disk drive
problems" on page 131.
Note: You might have to reconfigure the disk arrays after you install hard disk
drives.
88
ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide
Mixing hard disk drives with different speed ratings will cause all drives to
operate at the lower throughput speed.
the drive bay.
1
Handle
2
Latch
3
Filler panel handle
To maintain proper system cooling, do not operate the server for more
the hard disk drive is operating correctly.