Enabling Spbm; Configuring Customer-Side Settings On Bebs; Enabling L2Vpn - H3C S12500 Series Configuration Manual

Step
1. Enter system view.
2. Enter MST region view.
3. Configure the MST
region name.
4. Configure the MSTP
revision level.
5. Map B-VLANs to MSTI
4092.
6. Activate the MST region
configuration.

Enabling SPBM

You must enable SPBM both globally and on the provider network ports on all BEBs and BCBs in the
SPBM network.
To enable SPBM:
Step
1. Enter system view.
2. Enable SPBM globally.
3. Return to system view.
4. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
5. Enable SPBM on the
interface.

Configuring customer-side settings on BEBs

All tasks in this section are required.

Enabling L2VPN

Step
1. Enter system view.
2. Enable L2VPN.
Command
system-view
stp region-configuration
region-name name
revision-level level
instance instance-id vlan
vlan-id-list
active region-configuration
Command
system-view
spbm
quit
interface interface-type
interface-number
spbm enable
Command
system-view
l2vpn enable
17
Remarks
N/A
N/A
The default MST region name is the MAC
address of the device.
The default MSTP revision level is 0.
By default, all VLANs are mapped to the
CIST (MSTI 0).
The value for the instance-id argument must
be 4092.
N/A
Remarks
N/A
By default, SPBM is disabled globally.
N/A
N/A
By default, SPBM is disabled on interfaces.
Remarks
N/A
By default, L2VPN is disabled.