4.
To remove the touch/control panel
assembly:
a) Remove the ribbon cables at P4 and P5
(see step 3c on page 4-6).
b) Remove the locking rings from the
notched ends of the two ribbon cables,
and install them on the ends of the new
touch / control panel assembly ribbon
cables.
Notch
Locking
Ring
c) Remove the two screws from the elec-
tronic oven control board bracket and
remove the board and bracket from the
control panel assembly.
Screw
EOC Board & Bracket
d) Remove the two screws from each of
the two end caps and remove the caps.
NOTE: The touch/control panel and glass are
replaced as an assembly.
Screw
4-7
End Cap
Screws
Touch Panel
Control Panel & Glass