Speaker Layout; Connecting A Tv; Connecting An External Component; Connecting The Power Cord - JVC TH-S11 Service Manual

Connections

Speaker layout

Center speaker
Front left
speaker
Surround left
speaker
NOTE
• Place the satellite speakers on a flat and level surface.
• The front and center speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, they may
cause color distortions. So, pay attention to the following when
installing the speakers.
– When placing the speakers near a TV set, turn off the TV's main
power switch or unplug it before installing the speakers. Then wait
at least 30 minutes before turning on the TV's main power switch
again.
Some TVs may still be affected even though you have followed the
above. If this happens, move the speakers away from the TV.
• The surround speakers and the subwoofer are not magnetically
shielded.
If it is located nearby the TV or monitor, it will probably cause
color distortion on the screen. To avoid this, do not place the
speaker nearby the TV or monitor.
• Be sure to place the subwoofer to the TV's right. If you place the
subwoofer to the TV's left, keep sufficient distance between them to
prevent the TV screen from appearing mottled.

Connecting a TV

• Distortion of picture may occur when connecting the TV via a
VCR, or to a TV with a built-in VCR.
• You need to set "MONITOR TYPE" in the PICTURE menu
correctly according to the aspect ratio of your TV. (See page 30.)
7 To connect a TV equipped with the component video
input jacks
Center unit
Component video cord (not supplied)
NOTE
• If your TV supports progressive video input, you can enjoy a high
quality picture by setting the progressive scan mode to active. (See
page 13.)
• If the component video input jacks of your TV are of the BNC type,
use a plug adapter (not supplied) to convert the pin plugs to BNC
plugs.
• The video signals can be output only when you select "DVD" as the
source to play. (See page 12.)
9
Do not connect the power cord until all other connections have been made.
7 To connect a TV equipped with the S-VIDEO and/or
Front right
speaker
Subwoofer
NOTE
• Select the appropriate scan mode according to your TV. (See page
Surround right
speaker
You can enjoy the sound of an analog component.
NOTE
• If you connect a sound-enhancing device such as a graphic equalizer
• When playing a video component such as a VCR;
Make sure that all other connections have been completed.
TV
CAUTION
To component
• Disconnect the power cord before cleaning or moving the system.
video input
• Do not pull on the power cord to unplug the cord. When unplugging
NOTE
• Preset settings, such as preset stations and surround mode adjustment,
the composite video input jacks
Center unit
Composite video cord
(supplied)
13.)
Connecting an external
component
Center unit
RCA pin plug cord
(not supplied)
between the source components and this system, the sound output
through this system may be distorted.
To listen to the sound, select "AUX" as the source to play. (See
•
page 12.)
To see the picture, connect the video output jack of the component
•
to the video input jack of the TV directly, and select the correct
input mode on the TV.
Connecting the power
cord
Center unit
Power cord
Plug into AC outlets.
the cord, always grasp and pull the plug so as not to damage the cord.
may be erased in a few days in the following cases;
If you unplug the power cord of the center unit.
•
If a power failure occurs.
•
S-VIDEO cord
(not supplied)
TV
To audio output
VCR
TV
Cassette recorder