HAEGER Design Chrome TW-25C.005A Manual page 5

• Always observe the valid national and international safety, health and work
regulations.
• The device may only be connected to a socket with a properly installed
protective contact.
• Before connecting the device, it must be ensured that the mains connection
corresponds to the connection data of the device.
• The input voltage of this product is 220-240V~, 50-60Hz. Before turning on,
ensure the electrical voltage and frequency of the circuit corresponds to those
indicated on the appliance.
• Protection must be provided with a residual current circuit breaker (FI switch)
with a rated residual current of no more than 30 mA.
• Do not touch the mains plug with wet hands!
• Always pull the mains plug by the plug, not the cable.
• Do not kink, crush, pull or run over the mains cable; protect from sharp edges,
oil and heat.
• Do not lift the device by the cable or otherwise misuse the cable.
• Check the plug and cable before each use.
• If the mains cable is damaged, pull out the mains plug immediately. Never use
the device with a damaged power cord.
• The mains plug must always be pulled out when not in use.
• Before plugging in the mains plug, make sure that the device is switched off.
• Always switch off the device before pulling out the mains plug.
De-energize the device during transport.
•
• If the power cord of this device is damaged, it must be replaced by the
manufacturer or its customer service or a similarly qualified person in order to
avoid hazards.
Watch out for cables and gas and water lines when drilling in walls, ceilings or
•
floors.
• The environment must be free of highly flammable or explosive substances.
The device must not be operated outdoors.
•
• The heater must not be placed directly below a wall socket.
Do not use any adapters or extension cords.
•
Close supervision is necessary when any appliance is used by or near
•
children. Children should be supervised to ensure that they do not play
with the appliance.
2
English -