Water Nozzle Installation - Toto 0G3861Y Instructions For Construction

Water nozzle installation

Preparation before installation:DV309S、DV309-3R
1.Cleaning in the water supply pipe
Before installation,be sure to remove by washing such foreign matters as dust,
sand,etc.in the water supply pipe;in installation,it is imperative to also take care
sufficiently not to allow such foreign matters as mud and sand,etc.to enter into
the water nozzle or the water supply pipe.
2.Installation of main water nozzle body
①As shown in Fig.I,connect properly the main water nozzle body an
corresponding pipe and then cut a slot on the wall surface by referring to the
beginning of the product.
Attention: a.Before water nozzle installation,be sure to do a water test to prevent
water leakage,etc.
b.In cutting slot,be sure to meet the dimensions as shown in the figure.
Fig.I
100
Dimensional unit:mm
②As shown in Fig.II,use such filling sa cement,etc.to install the product in the wall.
Attention:a.The exposed part from wall must not contact with such building
materials as cement,etc.
b.In installation,the product should be kept perpendicular to the wall
surface.
Fig.II
Protective sleeve
Attention:For the water nozzle with a protective sleeve,remove the protective
sleeve and loosen the screws to pull the protective sleeve out.
(After installation,the protective sleeve will have no use.)
14
Plug body
Shower side
Body
Cold water pipe
Fixing ring
Hot water pipe
Protective sleeve
To bath tub
Completion
Screw
wall surface
Protective sleeve
Water nozzle installation
Preparation before installation:DV311-2R、DV311-3
Chisel at the burial wall location by referring to the completion figure.
Dimensional unit:mm
1.Cleaning in the water supply pipe
Before installation,be sure to remove by washing such foreign matters as dust,
sand,etc.in the water supply pipe;in installation,it is imperative to also take care
sufficiently not to allow such foreign matters as mud and sand,etc.to enter into
the water nozzle or the water supply pipe.
2.Connection of water nozzle and pipe
Provide pipe between the side with marking S on the body and the shower.
Body
Hot water pipe
100
Plug body
Shower side
Body
Marking S
Plug body
Protective
(forbidden to)
sleeve
Cold water pipe
Fixing ring
Marking B
15