Advertisement
Water nozzle installation
1.Installation of main body of water nozzle
As shown in the diagram, remove
①
the securing nut and horseshoe-
shaped gasket in the lower part of
the body.
Adjust the direction of the body
②
so that it is installed on the face
wash basin with the front side
facing forward.
Use horseshoe-shaped gasket
③
and securing nut to fix the water
nozzle onto the face wash basin
from the lower part thereof.
Occasion provided with a
flow-limiting accessory
Flow-
limiting
accessory
Attentions:Before connecting into the water supply pipe,be sure to confirm if filter
gasket is available in the fastening nut.
When connecting the fastening nut with water inlet pipe,please use water stop
valve for connection.
Whe installing,first remove the connecting hand and install to the standby pipe
of customer,then install the pressure-resistant hose.
The pressure-resistant hose has been installed before ex-factory.Therefore,
customer is not allowed to screw the hexagonal nut when install and use.
In order to keep the main body from loosening,please screw tight the securing
nut.
The product installation principle is basically the same for different examples.
8
Face wash basin
Horseshoe
shaped gasket
Hexagonal nut
Securing the nut
Fastening nut
Water nozzle installation
2.Installation of water drainage fittings(example)
Installation of main drainage body
①
Seal surface
Washer
Main water
drainage body
Nut
Lever screw
thread hole
a.Remove the water drainage head and
seal ring from the main water drainage
body.
b.Then put the main water drainage body
in from the lower side of the face basin.
c.Combine the water drainage head and
seal ring onto the main water drainage
body from the upper side of the face
basin.
d.Adjust the direction of the screw hole to
install the lever so that it faces right
against the wall.
e.Screw the nut to an appropriate
position to avoid face basin being
damaged.
Installation of water drainage plug
②
lever hole
Washer Nut
Water
Lever
stop
plug
a.Please pay attention to the direction
of the water stop plug.
b.Insert the lever through the lever hole
into the water stop plug hole.Then
screw tight the nut.
Draw bar installation
③
Attentions:When the
distance between
the water drainage
center and the
draw bar center is
Draw bar
less than 150mm,
the operating force
may be too high.
The draw bar can
be bent to increase
the center distance
and reduce the
operating force of
the draw bar.
Screw
Connecting
slide
Screw
Lever
a.As shown in the diagram,first put the
lever through the connecting slide.
Then use connecting nut to secure
the draw bar and connecting bar.
Adjust the position of the connecting
slide to make the lever and water stop
plug be in an appropriate position and
secure with screw.
b.Iower nomally,customer is requested
to adjust the position of the connecting
slide on the connecting bar and lever
by himself.
9
Advertisement
Chapters
