Toto 0G3861Y Instructions For Construction page 21

Water nozzle installation
Decorative plate and handle part installation(II)
DP352and DV309-3R water nozzle
First install the fixing sleeve onto the valve body.Use the screws removed from the
protective sleeve to fix the fixing plate onto the body.Install the decorative plate.
Point the square hole in the handle part at the square convex part at the front end
of the valve body and push in.Fix with the handle part through the O-ring of the valve
body part and use screws to fix the handle.Install the switching handle into the
switching valve and fix by using screws.(If it is unable to push the handle part in
completely when fixing the handle part and valve body O-ring,please pull the
decorative plate out appropriately.After fixing completely the handle part and O-ring
part,then push the decorative plate to fit with the wall surface.)
Decorative plate
Handle knob
Handle
Small screw
Hex wrench
18
Fixing sleeve
Fixing plate
Screw
Fixing plate Valve body
Water nozzle installation
Decorative plate and handle part installation(III)
DP349 and DV311-2R water nozzle
First use the fixing screws to fix the fixing plate onto the valve body.Then install the
decorative cover,decorative plate and decorative ring (the decorative plate and
decorative ring are to be compressed tightly onto the wall).Then use small screws
to fix the handle and spline receiving hand onto the valve core.Finally,install the
indicating cover onto the handle.
Parking
Handle
O-ring
Fixing plate
Screw
Decorative plate
Receiving hand
Small screw
Attention: a.The positions of differen parts.
b.Tighten the small screws.
Indicating cover
c.Fasten the decorative ring.
d.Do not reverse the direction of
the handle.
Hex wrench
e.When the main installation
distance on the wall is 50～60mm,
please use two long screws for
securing.
Decorative
cover
Valve body
19