Table of Contents
Advertisement
Service condition and attentions in construction
Service condition
1. Cold water supply*hot water supply pressure
Minimum pressure ..................... 0.05MPa (flow pressure)
Maximum pressure ..................... 1.0MPa (static pressure)
2. When the sprinkler is used as ancillary component,it is advised that the water
pressure should be more than 0.2Mpa,otherwise,the performance of the sprinkler
can not be played fully.
3. The temperature for water supply is 4~90℃. It is suggested to use the hot water
temperature 60±5℃, Do not use steam to supply hot water.
4. The ambient temperature for use is above 0℃. If not, the water tap may deform and
crack due to freezing.
5. To prevent internal sprinkler damage,the water outlet temperature on the sprinkler
side shall not exceed 60℃.It is suggested to use a temperature below 45℃.
6. Being out of use for a long time may result in internal and external rust to the
water nozzle and being unable to be used.
7. If you want to scrap this product, do not treat it as you do for general domestic
grabage. Please follow relevant statutes to have it treated, recovered and collected
appropriately by an independent recovery system.
8. The product in these instructions has a cleaning function.
Attentions in construction
Warning:it means that ignoring this mark and misoperation may cause
serious personal injury and death.
Attention: it means that ignoring this mark and misoperation may cause
personal injury or property loss.
1.The hot water supply side of the water nozzle is in a condition of high
temperature. Do not allow skin to contact with the hardware surface
directly.Otherwise,scalding may occur.
2.Do not reverse cold*hot water pipes. Otherwise, scalding may occur.
3.Do not use steam to supply hot water. Otherwise, scalding may occur.
4.In construction, do not install and use the G1/2 or G3/4 internal threads
of this product with R1/2 or R3/4 connector. Otherwise, the main body
threads may crack, resulting in such quality problems as water leakage,
etc.
4
Warning
Attentions in construction and maintenance
1. As the ceramic spool is a precise component, do not dismantle it without
authorization. Otherwise, such poor conditions as water leakage, etc. may
be caused.
2. Do not impact the product. Otherwise, failure, water leakage may occur.
3. It is imperative to use a neutral detergent in cleaning. Other detergents
than a neutral one may damage the plating coat or make the surface
discolor.
4. Do not use any such detergent as acidic detergent and abstergent,
polishing powder, etc. Containing thick particles and nylon brush.
Otherwise, the plating coat may be damaged, etc.
5. It is allowed to use a piece of soft cloth to wipe or use from time to time a
piece of cloth immersed in machine oil or vehicle wax to wipe. However,
do not contact with resin components. Otherwise, they may lose the gloss
and become rusty.
6.It is suggested not to leave it unused for a long time.Otherwise,this may
lead to internal and external rust to faucets to such a degree that it cannot
be used any more,etc.
7. With the product design being updated constantly,the physical object
may not coincide with the figure.However,the basic principle for
installation,use is the same.
Maintenance
To maintain a beautiful appearance of the product, the user is requested to
conduct maintenance and care in the following method.
1. Wipe with a piece of soft cloth frequently and use a piece of soft cloth
dipped in water to wipe from time to time.
2. When dirt exists obviously, please use water to wash sufficiently after
wiping with a neutral detergent.
Attentions
5
Advertisement
Chapters
Table of Contents
