Advertisement
Step 3. Install your front wheel.
E.
Lift the front of the bike and roll the front wheel in-between the brake
pads with the lever head on the left side of the bike. Carefully align
and lower the fork onto the wheel axle. Ensure the brake pads are in-
line with the rim and the wheel axle is fully seated in the fork dropouts.
F.
While holding the lever head of the skewer, begin tightening the
adjusting nut in a clockwise direction. Remember, "righty tighty".
G.
Close the lever. If you don't feel significant tension when the lever is
closed, open the lever and continue tightening the adjusting nut until
adequate tension is achieved. When properly tightened, the lever
should leave a mark in your hand.
H.
Close the cable release at the brake caliper, then remove any additional
packaging from the bike.
SET-UP
STEP 1
STEP 2
STEP 3
E
F
G
H
STEP 4
PRE-RIDE CHECK
Advertisement
