Table of Contents
Advertisement
Problems with cleaning procedure
Description
The water drawer is difficult to
clean.
There is no water inside the grill -/
roasting pan after descaling.
There is dirty water on the bottom of
the cavity after descaling.
There is too much water on the bot‐
tom of the cavity after cleaning.
Cleaning performance is not satis‐
factory.
Power cut always stops cleaning. Repeat
cleaning if it's interrupted by power failure.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F111 - Food sensor is not correctly inserted into the
socket.
F240, F439 - the touch fields on the display do not
work properly.
F908 - the appliance system cannot connect with the
control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the appliance functions will continue to
work as usually.
32
ENGLISH
Possible cause
The lid and the wave breaker were
not removed.
The water drawer was not filled in to
the maximum level.
The grill -/ roasting pan is on a
wrong shelf position.
You put too much detergent in the
appliance before you started clean‐
ing.
You started cleaning when the appli‐
ance was too hot.
You did not remove all the accesso‐
ries from the appliance before
cleaning.
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Turn the appliance off and on.
Remedy
Remove the lid and the wave break‐
er.
Check if a descaling agent / water is
present in the water drawer body.
Remove the remaining water and
the descaling agent from the bottom
of the appliance. Next time put the
grill -/ roasting pan on the first shelf
position.
Next time evenly spread the thin lay‐
er of a detergent on the cavity walls.
Wait until the appliance is cold. Re‐
peat cleaning.
Remove all the accessories from the
appliance. Repeat cleaning.
Remedy
Advertisement
Table of Contents
