Manual Program Mode - Miller Multimatic 255 Owner's Manual

6-9.

Manual Program Mode

1
3
5
1 Program Button
2 Program Soft Keys
3 Left Knob
4 Right Knob
5 Home Button
The unit can store four programs for MIG,
four for Stick, and four for TIG. The pro-
grams have default setting saved when the
machines come from the factory.
Saving Programs In Manual Mode
To enter the Program menu from the Manual
Mode home screen, press the Program
button.
OM-278174 Page 44
�
Complete Parts List is available at www.MillerWelds.com
White Program tabs will appear above four
of the soft keys.
Determine where you would like to save the
settings. Push and hold that Program soft
key for two seconds. The display will show
"Saved" when the program has been suc-
cessfully saved.
Saving Programs From Auto-Set Mode
Program mode cannot be accessed from
Auto-Set mode. To save settings, note the
weld parameters and return to Manual mode
to access Program mode.
Recalling Programs
Push the Program button to select desired
program. The selected Program tab will turn
blue and the proper setting will be displayed.
2
Weld parameters may be changed while us-
ing the program with the left and right knobs.
If the settings are changed, the program tab
will turn white and the lettering will turn
black. To save the new settings, press and
hold the Program button again for two
seconds.
If you change the setting but do not wish to
save it, press the Program button again to
recall the original settings.
Exiting Program Mode
Press the Home button to exit Program
mode and return to Manual mode.
�
To use optional MDX-250 EZ-Select
MIG gun with Program mode, see
Section 6-10.
4