Using Auto-Set; Elite - Miller Multimatic 255 Owner's Manual

6-3.

Using Auto-Set

13
11
12
1 Process Buttons
Select desired welding process.
2 Auto-Set Button
Press to turn Auto-Set On or Off.
3 Pulse Button
Press to turn Pulse On or Off for MIG or TIG
process.
4 Material/Gas, Rod, And TIG Remote Left
Button
5 Material/Gas, Rod, And TIG Remote
Right Button
Press to select material and gas for MIG,
rod for Stick, and remote control status for
TIG. Left button moves cursor to the left,
right button moves cursor to the right.
OM-278174 Page 38
�
Complete Parts List is available at www.MillerWelds.com

Elite

™
1
9
4 5
6 Diameter Button
Selects the size of the wire, rod, or tungsten
for the selected process.
7 Material Thickness Left Button
8 Material Thickness Right Button
Use to select material thickness. Left button
moves cursor to the left, right button moves
cursor to the right.
9 Left Knob
Use left knob to fine tune voltage in MIG
mode, arc length in Pulsed MIG mode, and
pulse frequency in Pulsed TIG mode.
10 Right Knob
2 3
6 7 8
Use right knob to fine tune wire feed speed
in MIG mode and amperage in Stick or TIG
mode.
�
11 Welding Output Icon
When visible, indicates weld output is on.
12 Improper Weld Polarity Icon
When visible, indicates electrode and work
cables need to be switched.
13 Bullseye Indicator
Represents factory default settings.
277656-C
10
When using a spoolgun or push-pull
gun in Auto-Set, the potentiometer on
the gun is deactivated. Wire feed
speed is controlled on the front panel.