Threading Welding Wire For Spoolmate 200 - Miller Multimatic 255 Owner's Manual

5-19. Threading Welding Wire For Spoolmate 200

philips head wrench
nutdriver
wirecutter
1 Cover
2 Canister
3 Thumbscrew (Cover)
Loosen thumbscrew, and rotate cover open.
4 Wire Spool
Loosen wire from spool, cut off bent wire,
and pull 6 in (150 mm) of wire off spool.
greasegun
file
flashlight
�
Complete Parts List is available at www.MillerWelds.com
6
7
crescent wrench
chippinghammer
frontcutter 5 Pressure Roll Assembly
Press arm inward to open pressure roll
assembly.
6 Wire Inlet Guide
7 Drive Roll Groove
8 Contact Tip
filterwrench
paintbrush
ruler
5
8
3
1
2
9
4
Ref. 243 740-C
Thread wire through wire inlet guide, along
drive roll groove, and out contact tip.
Install spool so wire feeds off top.
9 Spool Brake Thumbnut
If necessary, turn thumbnut counterclock-
wise slightly to install spool.
Close cover and secure with thumbscrew.
OM-278174 Page 33