Threading Welding Wire For Spoolmatic 15/30A - Miller Multimatic 255 Owner's Manual

5-20. Threading Welding Wire For Spoolmatic 15/30A

wrench
crescent wrench
nutdriver
chippinghammer
wirecutter
1 Cover
2 Canister
3 Canister Cover
4 Thumbscrew (Canister Cover)
Loosen thumbscrew, and remove cover.
5 Wire Spool
Loosen wire from spool, cut off bent wire,
and pull 6 in (150 mm) of wire off spool.
greasegun
filterwrench
6 Pressure Roll Assembly
file
OM-278174 Page 34
�
Complete Parts List is available at www.MillerWelds.com
6
9
frontcutter Lift arm and open pressure roll assembly.
7 Canister Inlet Guide
8 Drive Roll Groove
For wire sizes .035 in. (0.9 mm) and
smaller use small groove, and .047 in.
(1.2 mm) and 1/16 in (1.6 mm) use large
groove.
9 Contact Tip
Thread wire through canister inlet guide,
along drive roll groove, and out contact tip.
paintbrush
8 7
2
11
1
10
3
4
5
150 436-F
Install spool so wire feeds off bottom.
10 Spool Brake Thumbnut
If necessary, turn thumbnut counterclock-
wise slightly to install spool.
11 Thumbscrew (Canister Rotation)
Loosen thumbscrew to rotate canister.
Close and secure pressure roll assembly
Reinstall top cover and canister cover.