Manual Tig Set-Up Mode - Miller Multimatic 255 Owner's Manual

6-7.

Manual TIG Set-Up Mode

1
2
4
1 Set-Up Button
2 Left Knob
3 Right Knob
4 Home Button
To enter the Setup menu from the Manual
Mode home screen, press Setup.
Once in the Setup menu, rotate the left knob
to find a particular item, and rotate the right
knob to change setting or status.
Press Home to save settings and return to
welding mode.
OM-278174 Page 42
�
Complete Parts List is available at www.MillerWelds.com
Items that can be adjusted from this menu
are:
Remote:
Enabled: When using a fingertip control or
foot pedal to activate and control welder
output.
Disabled: Output of welder is always on.
Output of machine is set by right knob.
Postflow: :The amount of time the shielding
gas will flow after the arc has been shut off.
Postflow setting range is from Disabled to
10 seconds.
277656-C
In the Auto Postflow setting, gas will flow for
one second for each 10 welding amps, up to
10 seconds.
Pulse: Reduces heat input to minimize dis-
tortion and increase travel speed. A low
speed pulse (up to 10 pulses per second)
can be used to time the addition of filler ma-
terial, resulting in a distinct ripple pattern. A
high speed pulse (over 100 pulses per sec-
ond) can increase the travel speed while in-
creasing penetration. Pulse setting range is
0.1 to 150 pulses per second.
3