urmet domus iPercom VOG 5+ 1761/15 User Booklet page 45

5.9. FLOOR CALL
If a floor call is received, the video door phone starts ringing with the ringtone chosen by the user.
The function is only available if a key has been connected to the "FC" terminals.
When a call is received, the floor call icon is shown in the upper left corner of the display:
5.10. DOOR OPEN INDICATION
The video door phone has the icon
door has remained open on one or more entries. The door open condition is signalled by the call stations
only if the duration of this event is at least 30 seconds.
The feature must be enabled by the installer when configuring the Ipercom system.
The feature is related to the SP terminal status of the calling stations and requires an open door sensor.
ATTENTION! The open door indication is displayed only on the video door phones through which the door
has been opened after the last call received.
In addition to the icon on the display, the LED of the key
red and flashes.
When the door or any doors left open are closed, the icon will no longer be visible on the display and the
LED of the key
5.11. PANIC ALARM
The panic alarm signal is sent from the video door phone to the switchboard in the system and to all
smartphones in which the call forwarding function has been activated via the CallMe app.
SEND TO SWITCHBOARD
ATTENTION! The panic alarm function assumes that:
• the system has a switchboard;
• the system has been configured appropriately (see the
• there is an operator on duty at the switchboard;
• the switchboard operator has been duly instructed on what to do if a panic alarm is received.
When the key is pressed, the video door phone sends a panic alarm signal.
When the panic alarm is sent, the following icon
When the switchboard operator receives a Panic alarm signal, he/she can listen to what is happening in the
flat, near the video door phone. Listening can only be interrupted by the switchboard operator and has no
time limits. Enabling listening in the flat must be carried out by the installer during configuration (for more
System technical
information see the
SEND TO CALLME APP
If a call forwarding function has been configured in the video door phone, the "Panic Alarm" signal is also
DS1761-038
, in the lower left part of the display, which indicates whether the
will stop flashing.
manual).
on the video door phone light up
System technical
is displayed on the Homepage.
manual);
45