Check Point SandBlast TE2000XN Series Manual page 10

4. Carefully pull the DIMM up.
Important - Only touch the rear corners of the DIMM. Pressing on the heat sink or
other DIMM components can damage the hardware.
If necessary, pull one end of the DIMM, then the other, to gradually release it from the contact pins.
Important - Make sure that there are no leftover parts inside the appliance.
5. Make sure the DIMMs are installed correctly.
a. Replace the appliance cover without tightening the appliance cover screws.
b. Connect the power cords to the appliance.
The appliance turns on.
6. Tighten the appliance cover screws to secure the cover on the appliance.
Installing and Removing Memory in SandBlast TE2000XN-28VM/56VM Appliances | 10
SandBlast TE2000XN Appliances Installing and Removing Memory