Table of Contents
Advertisement
Quick Links
EVALUATION FOR ICs
TRAMS Getting Started
+
+
T
C
ABLE OF
ONTENTS
1
Step 1: Software ........................................................................................................................................................... 2
2
Step 2: Installation ...................................................................................................................................................... 2
3
Step 3: Firmware upload ........................................................................................................................................... 2
4
Step 5: Connect with the 3D printer ..................................................................................................................... 3
5
Step 6: Powering up ................................................................................................................................................... 5
6
Step 7: Printing ............................................................................................................................................................. 5
7
Life Support Policy ....................................................................................................................................................... 6
8
Revision History ............................................................................................................................................................ 7
8.1
Firmware Revision .............................................................................. Fehler! Textmarke nicht definiert.
8.2
Document Revision ............................................................................................................................................. 7
9
References ...................................................................................................... Fehler! Textmarke nicht definiert.
TRINAMIC Motion Control GmbH & Co. KG
Hamburg, Germany
EVALUATION BOARD
TRAMS
+
TRINAMIC Reprap Arduino Mega
Shield
Application specific Reference
Design for 3D-Printers with
TMC5130 Motor Controller /
Driver for Two Phase Stepper
Motors
Up to 4x 1.1A RMS/ +12V... 24V DC
SPI
2x Ref. Switch Input per Axis
+
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Trinamic TRAMS TMC603-EVAL
Summary of Contents for Trinamic TRAMS TMC603-EVAL
- Page 1 Step 7: Printing ................................5 Life Support Policy ............................... 6 Revision History ................................7 Firmware Revision ................Fehler! Textmarke nicht definiert. Document Revision ............................. 7 References ...................... Fehler! Textmarke nicht definiert. TRINAMIC Motion Control GmbH & Co. KG Hamburg, Germany...
- Page 2 To test if the firmware was uploaded properly start Repetier-Host and press Strg+p. Now choose your USB port and set the baud rate to 56000. Click on “Connect”. You should now see a similar text in the lower log window: www.trinamic.com...
- Page 3 Connect the end stops for the X-, Y- and Z-Axis. The Extruder normally doesn’t need an end stop. IMPORTANT: Right now, the firmware only supports using one end stop per axis which needs to be the left one. Connect the end stops as shown here: www.trinamic.com...
- Page 4 Watch out for the right polarity. If you have a fan or lights which needs to be powered all the time you can connect them to the two VM ports: If you have a heatbed connect it to the HEATBED port. www.trinamic.com...
- Page 5 If you have a heatbed you need to connect V_HEATBED to 12-24V, too. Connect the Arduino with the computer. Step 7: Printing Start Repetier-Host and click on “Connect”. Click the homing button: Your printer should now home. You are now ready to print. www.trinamic.com...
- Page 6 TRAMS getting started / (Rev. 1.00 / 2015-OCT-26) Life Support Policy TRINAMIC Motion Control GmbH & Co. KG does not authorize or warrant any of its products for use in life support systems, without the specific written consent of TRINAMIC Motion Control GmbH & Co. KG.
- Page 7 TRAMS getting started / (Rev. 1.00 / 2015-OCT-26) Revision History Document Revision Version Date Author Description 1.00 2015-OCT-26 Initial version Table 8.1 Document revision www.trinamic.com...
Need help?
Do you have a question about the TRAMS TMC603-EVAL and is the answer not in the manual?
Questions and answers