Charging With The Multirae Desktop Cradle - Honeywell MultiRAE Series User Manual

Battery
Always make sure the batteries are fully charged before using the MultiRAE. Three battery
options are available for the MultiRAE (PGM 62x6/62x8):
1. Standard duration rechargeable Li-ion battery (PN: M01-3053-000)
2. Extended-duration rechargeable Li-ion battery delivering 50% more runtime than the
standard battery (PN: M01-3055-000)
3. Alkaline battery pack for four standard AA-sized batteries (PN: M01-3054-000)
Its standard or extended-duration batteries are charged inside the instrument by placing the
MultiRAE in its cradle or using the Travel Charger. Contacts on the bottom of the instrument
meet the cradle's contact pins, transferring power.
Note: Before setting the MultiRAE into its MultiRAE Desktop Cradle or attaching its Travel
Charger, visually inspect the contacts to make sure they are clean. If they are not, wipe them
with a soft, dry cloth. Do not use solvents or cleaners.
WARNING
To reduce the risk of ignition of hazardous atmospheres, recharge, remove or replace the
battery only in an area known to be non-hazardous! Do not mix old and new batteries or
batteries from different manufacturers.

Charging with the MultiRAE Desktop Cradle

Follow this procedure to charge the MultiRAE:
1. Plug the AC/DC adapter into the MultiRAE's Desktop Cradle.
2. Plug the AC/DC adapter into the wall outlet.
3. Place the MultiRAE into the cradle (make sure the bottom of the instrument and the
alignment pins on the cradle mate properly) and press down until it is locked in place.
The MultiRAE begins charging automatically. The LED in the cradle should glow red to indicate
charging. When charging is complete, the LED in the cradle glows green.
To remove the MultiRAE from the Desktop Cradle, tilt it toward you until it releases, and
l
then lift it up.
Press down until MultiRAE is seated firmly in the cradle
l
Release the MultiRAE by tilting it forward and lifting
l
Honeywell MultiRAE Series™ 41 User Manual