Configuring Ble; Ble Modes - Honeywell MultiRAE Series User Manual

CHAPTER
19

Configuring BLE

(BLE-Equipped Instruments Only)
If your MultiRAE is equipped with a BLE module, you can turn it on or off through the Wireless
Radio ON/OFF menu in Programming mode. You can also use Safety Suite Device Configurator
(SSDC).
On the instrument, you can check which of two configurations is selected (App Mode or Profile
Mode). Start at the main screen and press [N/-] repeatedly until you see either of this screen:

BLE Modes

BLE can be configured in either of two modes: DC Mobile App Mode or Profile Mode. By default,
all BLE-equipped instruments are set in App Mode. Using Safety Suite Device Configurator
(SSDC), you can switch between the two BLE modes:
App Mode
Allows an instrument to be compatible with all Honeywell Mobile Apps (Safety Communicator
and Device Configurator).When in App Mode, an instrument is not compatible with third-party
solutions.
Profile Mode
Profile Mode allows an instrument to be compatible with third-party wireless infrastructure.
Please engage with Honeywell support to understand approved third-party systems supported by
Profile Mode.
When in Profile Mode, an instrument is absolutely not compatible with Honeywell mobile apps.
In App Mode, you can turn BLE on or off, plus set a BLE PIN Number in Safety Suite Device
Configurator (SSDC). You can also view the MAC Address.
In Profile Mode, you can only turn BLE on or off.
Honeywell MultiRAE Series™ 172 User Manual