Problem 13 - Engine Will Not Crank (220/410/530Cc Engines With Electric Start); Problem 14 - Recoil Cord Will Not Pull (If So Equipped) (220/410/459/530Cc Engines) - Generac Power Systems XT-EFI Series Manual

Problem 13 – Engine Will Not Crank (220/410/530cc Engines with Electric Start)
TEST 15 – CHECK
BATTERY
& CABLES
BAD
RECHARGE OR REPLACE BATTERY
– CLEAN, REPAIR OR REPLACE
BAD CABLE(S)
Problem 14 – Recoil Cord Will Not Pull (If So Equipped) (220/410/459/530cc Engines)
TEST 33 – TEST
RECOIL
FUNCTION
BAD
REPLACE
Diagnostic Repair Manual
TEST 16 – CHECK
VOLTAGE AT
GOOD
STARTER
CONTACTOR
12 VDC
MEASURED
TEST 19 – CHECK
STARTER MOTOR
GOOD
TEST 34 –
GOOD TEST ENGINE
FUNCTION
BAD
VISUALLY INSPECT EXTERNAL
COMPONENTS FOR A FAILURE
THAT WOULD CAUSE THE
ENGINE TO BE SIEZED
NOTHING
FOUND
Section 5 Engine Diagnostic Tests
NO VOLTAGE
MEASURED
REPLACE STARTER
BAD
MOTOR IF DEFECTIVE
CHECK FOR MECHANICAL BINDING
OF THE ENGINE OR ROTOR
VISUALLY INSPECT FOR OBSTRUCTIONS
GOOD
THAT WOULD CAUSE BINDING OF THE
RECOIL ONCE INSTALLED
BAD
FIX BAD COMPONENT
AN INTERNAL ENGINE FAILURE HAS OCCURED.
POSSIBLE FAILURE COULD BE THE RESULT OF
A COMPRESSION RELEASE FAILURE. CONSULT
ENGINE SERVICE MANUAL P/N 0C1103A FOR
FURTHER ENGINE SERVICE INFORMATION.
TEST 17 – CHECK
START-RUN-STOP
SWITCH
BAD
REPLACE
23