Din Rail Mounting; Removing From The Din Rail; Wall Mounting Clip - Wieland wienet LTE LR140 EMEA User Manual

5.2

DIN Rail Mounting

The DIN rail clip is suitable for a DIN rail according to EN 60715 standard only. The default position of
NOTICE
the clip is shown in Figure 10.
When mounting the wall mounting clip, tighten the screws with max. torque of 0.4 Nm.
CAUTION
Figure 10: Position of the DIN Rail Clip
5.3

Removing from the DIN rail

 Push the router down lightly, so the bottom part of the DIN rail clip (hitched to the DIN rail) gets
out of the rail.
 Pull out the bottom part of the router away from the DIN rail.
Figure 11: Removing Router from the DIN Rail
5.4

Wall mounting clip

The router can be screwed to a wall (or another surface) using wall mounting clips. There are two
holes with a diameter of 4 mm. More detailed information about the installation dimensions can be
found Figure 6 in chapter 3.8 "Product Dimensions", p. 13.
Tightening the screws
 When mounting the wall mounting clip, tighten the screws with a max. torque of 0.4 Nm.
Wieland Electric GmbH | BA001293 | 02/2023 (Rev. A)
Mounting and Removal
17