Tech Specs - Slime PRO POWER Manual

Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A
CONFINED AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death
could occur. Always operate the inflator in a well-ventilated area free of combustible
materials, gasoline, or solvent vapors. Always set parking/emergency brake and ensure
vehicle is in Park (or neutral if equipped with manual transmission).
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING
NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR
It is recommended that you operate your inflator with your vehicle's engine
running to achieve the optimal inflator performance. Never start a vehicle with the
inflator plugged into the DC 12 Volt power socket.
• Do not attempt to disassemble inflator.
• No user serviceable parts inside. The only user serviceable part is replaceable fuse.
• Keep inflator out of reach of children.
• Place inflator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper inflation.
• DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inflator unattended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inflate.
• Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings.
Be careful not to inflate items beyond their capacity.
• While operating, never block the inflator input or output.
• For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with
older 8 amp cigarette lighter receptacles.

TECH SPECS

TIRE INFLATION TIME
CFM (LPM)
IN-LINE DIAL GAUGE
COIL AIR HOSE LENGTH
12V POWER CORD LENGTH
POWER SOURCE
TOTAL REACH
* (0-35 PSI, Standard Tire: P195/65 R15)
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS EXTREMELY
DANGEROUS. ALWAYS ALLOW FOR PROPER VENTILATION.
3 min*
1.25 CFM (35 LPM) @ 0 PSI
PSI 0-100, BAR 0-7
15 ft. (4.5 m)
10 ft. (3 m)
12V accessory power outlet
27.33 ft. (8.33 m)